Drejebordet kan belastes med maksimalt 5 kg

On MK10 extruders that limitation occurs around 60 mm/s

you should always remember that you will not get the same strength in the finished parts when using lower temperatures

With this you can print at 295°C "all day long"

Optimized for: UltiMaker PLA

FLUX - Charcoal Filter Replacement - Beam Air Creality 3D - Sermoon D1 - Reservedel Drejebordet kan belastes med maksimaltCharcoal Filter for your Beam Air It is recommended that the charcoal filter be replaced every 300 600 hours. Remember to also replace the other filters on time: See 3D Expert's selection of laser accessories here * Pre Filter (10 30 hours) * Medium efficiency filter (50 150 hours) * H13 HEPA filter (100 200 hours) * Charcoal filter (300 600 hours) Remove the filters: Open the top cover of the filter and remove the box from inside. Then take out the